Tools · Steam
IAPWS-IF97 steam tables
Thermodynamic properties of water and steam according to the IAPWS-IF97 industrial formulation, the same one boiler and turbine manufacturers use.
Gauge units use an atmospheric pressure of 1.01325 bar.
Result
TemperaturePressureSpecific volume
DensityEnthalpyInternal energyEntropy
Specific heat at constant pSpecific heat at constant vSpeed of sound
QualityLatent heat
Saturated liquidSaturated steamMixtureState
Compressed liquidSuperheated steamSupercritical fluid
Wet steamSaturated liquidSaturated steam
IF97 region
Enter a valid number.
Pressure must be between 0 and 1,000 bar.
Temperature must be between 0 °C and 2,000 °C.
Above 800 °C the maximum pressure is 500 bar.
Saturation exists between 0.01 °C and 373.946 °C.
Saturation exists between 0.00611 bar and 220.64 bar.
Steam quality must be between 0 and 1.
The enthalpy is outside the range of the formulation at that pressure.
The entropy is outside the range of the formulation at that pressure.
No solution was found this close to the critical point.
That point lies on the saturation curve: use the saturation mode or enter the steam quality.
About the formulation
- IAPWS-IF97 is the industrial formulation of the International Association for the Properties of Water and Steam. It covers 0 °C to 800 °C up to 1,000 bar, and 800 °C to 2,000 °C up to 500 bar.
- The implementation reproduces the verification values published by IAPWS for regions 1, 2, 3 and 5, the saturation curve and the boundary between regions 2 and 3.
- Enthalpy and entropy are referenced to zero for saturated liquid at the triple point, as in standard steam tables.
For reference only. Results are calculated in your browser and do not replace professional judgement or the design and test data of your equipment. Delta Mechanics accepts no liability for decisions based on this tool alone.
Is your steam cycle performing as it should?
With Tundra we model the whole cycle and compare it with measured performance.
